Phase 3 of 4 · planned
Closing the Loop
Plumb the drain-to-basin loop so it runs forever on its own water.
8
parts this phase
1 / 8
already owned
7
to buy
2
jobs for the kids
This is the plumbing: pull water from the lower basin's drain, through a visible strainer, into the crate and the pump, then back up and into the upper basin through two feeds so the rain trough and the maze column both run. The table's own mechanisms do the rest — water flows down through them and back to the drain. A closed loop on a few gallons.
After this phase: A continuous circuit: drain → strainer → pump → split → two basin feeds → through the table's rain and maze → back to the drain.
The thinking
Sized to 1/2" end to end
The whole system is 1/2": the strainer's NPT ports, the bulkheads, every barb. That means no reducers anywhere — fewer parts, fewer joints, fewer places to leak. The single best decision in the plumbing was picking one size and holding it.
Silicone tubing, because it lives outside
Vinyl and Tygon yellow, stiffen, and crack in the sun within a season. Silicone shrugs UV off, stays flexible, and is food-grade. The thick-wall (3/4" OD) version holds the barb seal and won't kink on the run up the back of the table. It's the one part not to cheap out on.
A strainer you can see into
The drain side pulls sand, leaves, and whatever a toddler drops in. The SEAFLO strainer's clear bowl makes the gunk visible and its 100-mesh stainless screen catches it before the pump; the bowl twists off to rinse. A dirty strainer you can see beats a clogged pump you can't.
The drain plug becomes the outlet — reversibly
Rather than cut the table, a spare Step2 drain plug gets drilled for a barb fitting, sandwiched between stainless washers and locked with a nut. It uses the existing tapered drain hole, and swapping the unmodified plug back undoes the whole thing. No permanent change to a toy that may outlive this project.
316L clamps, not 304
Every barb gets a stainless clamp instead of a quick-disconnect — it reads as intentional, and undoing ten of them at season's end takes about thirty seconds. 316L marine grade over the cheaper 304 because this is wet and outdoors, and 304 rusts.
Bill of materials
- SEAFLO SF-ST-12 inline strainerhave—
- Food-grade silicone tubing, 1/2" ID × 3/4" OD, 10ft ×2$16.99 ea
- Step2 drain plug 6-pack (drill one, keep spares)~$8
- 1/2" barb × 1/2" MIP nylon adapters (pack)$9.49
- 1/2" barbed tee$4.77
- 1/2" bulkhead fittings ×2~$10
- 316L marine stainless hose clamps, 10-pack$7.99
- PTFE thread tape~$3
For the kids
The fun-to-watch phase — and a couple of small hands help:
- Push the two feed tubes onto the basin fittings.
- Watch the first water get pulled through the clear strainer bowl.